![]() In this way, it is perfectly feasible to combine any of the controllers from single-axis to multi-axis systems and control all from a single, PC-based unified software interface. Our legacy APT System Software platform offers ActiveX-based controls which can be used by 3rd party developers working on C#, Visual Basic, LabVIEW™, or any Active-X compatible languages to create custom applications and includes a simulator mode to assist in developing custom applications without requiring hardware.īy providing these common software platforms, Thorlabs has ensured that users can easily mix and match any of the Kinesis and APT controllers in a single application, while only having to learn a single set of software tools. For improved control, the max velocity should be limited to 2.3 mm/sec. At 2.6 mm/sec, velocity ripple and distortion of the acceleration/deceleration profile may occur.The minimum incremental motion that the stage can repeatedly achieve within its standard error.The measured minimum incremental motion that the stage can achieve, also referred to as the minimum step size.When a stage is moved to a position and then returned to its original position, some motion is lost due to the lead screw mechanism.The average of the repeatability when a set position is approached from both directions.Power supplies are sold separately options are listed below. It is bundled with Thorlabs' Kinesis ® software, which supplies out-of-the-box stage control from a PC and enables support for common programming interfaces like LabVIEW, LabWindows, and ActiveX. Each KDC101 provides control for a single axis, with or without a PC. If desired, the Z812B actuator can be replaced by any manual or motorized 12 mm (0.47") actuator that includes a Ø3/8" barrel, including stepper motor actuators and manual micrometers.įor low-power stages such as the MT1-Z8 (MT1/M-Z8), Thorlabs recommends the KDC101 DC Servo Motor Controller. This actuator attaches to the stage using a flexure clamp that tightens around the Ø3/8" barrel. The included Z812B DC servo actuator features a 500 mm (1.64 ft) cable length, an internal limit switch to prevent travel outside of the intended range, and an encoder that provides 29 nm resolution (see the Specs tab for additional details). Photos of these adapters in use are shown below. Thorlabs' adapter plates and brackets provide a convenient way to mount the MT1-Z8 on an optical table or breadboard to allow several stages to be combined in XY, XZ, or XYZ configurations and to reduce the overall length of the stage by repositioning the stage's actuator. The stages feature hardened steel linear bearings for precision motion and long life. Horizontal loads of 20 lbs (9 kg) and vertical loads of 10 lbs (4.5 kg) are supported by the actuator's inline 67.49:1 planetary gear head. The moving platform contains holes for alignment pins that ensure orthogonality when the stage is stacked with other stages or connected to our accessories. Each stage is equipped with a 1.00" x 1.00" (25.0 mm x 25.0 mm) tapped hole matrix that includes seven 1/4"-20 (M6) taps for compatibility with standard optomechanics. The MT1-Z8 (MT1/M-Z8) Single-Axis Stage provides 12 mm (0.47") of travel along one axis, while the MT3-Z8 (MT3/M-Z8) Three-Axis Stage provides travel in three dimensions. Thorlabs' Motorized Translation Stages provide electronically controlled linear motion along a well-defined axis. Adapters Available for Breadboard Mounting and XY, XZ, and XYZ Arrangements.Carriage Contains Seven 1/4"-20 (M6) Taps.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |